DIY Custom Gutter Guard Kits

Yes, if you can safely work on a single-storey roof and use basic power tools. Coast Flow DIY kits are pre-measured, colour-matched and shipped with clear step-by-step instructions.

Measure the total lineal metres of gutter you want covered and note your roof type (tile, Colorbond, metal) and gutter profile. Send Keith a few photos and the measurements — he'll confirm what your kit needs to include.

Pre-cut mesh in your chosen Colorbond® colour, plus all clips, saddles, screws, trims and end caps needed for the job. Written and video instructions are included, along with free phone support.

A cordless drill or impact driver, tin snips, a tape measure, safety gloves and eye protection are the essentials. A ladder rated for the job and appropriate roof access equipment are also required.

A confident DIYer with a helper can complete most single-storey homes in a weekend. Two people is safer and considerably faster than solo work.

The materials are identical to the ones Coast Flow installs professionally. The finished result depends on the care taken during install — following the instructions carefully produces a long-lasting job.

It's possible on single-storey homes with straightforward rooflines, but two people is strongly recommended for safety, speed and cleaner joins.

A rated ladder set up on stable ground, gloves, safety glasses, non-slip footwear and — for anything beyond a low single-storey roof — a harness anchored correctly. Never work in wet, windy or extreme heat conditions.

Only if you have the correct height-safety equipment and experience. Most homeowners are better off booking a professional install for two-storey work.

Tile, Colorbond, corrugated iron, Trimdek and standing seam. Send photos when ordering and Keith will confirm the fixings needed.

Quad, half-round, box and squareline gutter profiles. Photos with your enquiry help us match trims and clips exactly.

Yes. DIY kits ship right across NSW, with delivery timing quoted at the time of order.

Most kits are cut, packed and dispatched within one to two weeks of the deposit being paid. Transit time depends on your address.

If a small offcut is short we can supply an extra piece. Send photos before starting and Keith will help you sanity-check your measurements.

Yes. Free phone support from Keith is included with every DIY kit — most snags are solved in a five-minute call.

Yes. The mesh needs to sit over clean gutters, so a full clean is required first. Take the opportunity to also flush the downpipes.

The full Colorbond® colour range is available for mesh and trims. Match to your existing roof or gutter for the cleanest finish.

Yes. The kit can be measured around an existing solar array. Send photos so Keith can plan the mesh runs around the panels.

Yes — Coast Flow can supply AS3959-compliant ember mesh with 2 mm aperture for BAL-rated properties. Specify your BAL rating when ordering.

Because kits are custom-cut to your measurements, they cannot be returned for a refund. Unused general components may be exchanged where practical.

No. The mesh and trims arrive pre-finished in your chosen Colorbond® colour and require no painting or sealing.

Under the first row of tiles or with saddles on metal roofs, and screwed or clipped to the gutter edge — the exact method is covered step-by-step in the instructions supplied with your kit.

You receive the manufacturer's product warranty (typically 10–25 years depending on the product). Workmanship is your responsibility on a DIY install.

Yes. If you want to extend coverage or add ember guard later, just contact Keith with your original order details and we'll match the product and colour.

Not when installed following the supplied instructions and using the fixings provided. Improvised fixings that pierce roof sheets in unapproved ways may affect your roof warranty.

The mesh is run around penetrations and closed off with trims to keep the roof line sealed. Include these in your photos so Keith can spec the right trims.